Digilegs Size & Fit Guide: How to Measure Correctly Before Ordering
Choosing the correct size is the most important step when ordering Digilegs or Monster Legs. Each pair is made to order, so accurate measurements ensure proper fit, comfort, and safe performance use.
Why Sizing Matters
- Balance and stabilityIncorrect sizing changes how weight transfers through the system.
- Comfort during extended wearPoor fit creates pressure points and fatigue.
- Performance safetyIncorrect alignment reduces control.
What You'll Need
- Soft tape measure
- A flat surface
- Ideally a second person
Important
Measure while standing naturally. Do not pull the tape tight.
How To Measure
Step 1
Knee to Ankle Length
Measure from the centre of your knee joint down to the centre of your ankle bone on the outside of your leg.
Tip
If you fall between two ranges choose the shorter option.
Step 2
Calf Circumference
Measure around the widest part of your calf approximately 4–6 inches below the knee.
Tip
If your measurement falls between two sizes choose the larger calf option.
Step 3: Check Weight Requirements
- Increased durability
- Better long term performance
- Added safety margin
Final Checklist Before Ordering
- ✔ Knee-to-ankle measured accurately
- ✔ Calf measured at widest point
- ✔ Between sizes → shorter height / larger calf
- ✔ Weight and costume load considered
Leave a comment